Summation Current Transformer

Definition: The transformer which is used for converting the three-phase quantities into the single phase quantity is known as the summation transformer. This transformer is mainly employed for the unbalanced condition in the system and due to fault condition so that the relay operates properly.

The connection of the summation current transformer is shown in the figure below. The line CTs are connected to the primary of the auxiliary CT. Each line CTs energise the different number of turns on the primary side of the auxiliary CTs. The resulting single-phase output appears across the secondary.

summation-transformer-circuit-diagram

The summation transformers are used for comparing the relaying quantities derived from the current in the three phases of the primary circuit. It converts the three phase system into positive, negative and zero sequence components.

The simple arrangement of the phase sequence current segregating network is shown in the figure below. The summated output will be according to the fault condition. The summated transformer have their limitations because of loss of discrimination due to condensation of information.

hase-sequence-current-segregating-network

The output amperes-turns from summation transformer may be expressed regarding symmetrical components in the form of MI0 + NI1 + PI2 where M, N and P depend on the choice of summated quantities. The ratio of the compared quantities, for example, at the end of a protected feeder say A and B is

summation-transformer-equation-1

The values of M, N and P depends on the summation transformer and the phase affected by the fault. The ideal condition assumes that the current transducers are linear in response and so also the summation devices. The summation device has less burden and also very simple as compared to sequence network filters.

1 thought on “Summation Current Transformer”

Leave a Comment

Your email address will not be published. Required fields are marked *